GE Electric Range Oven Temperature Sensor
Complete guide with costs, step-by-step instructions, and repair options
Temperature Sensor on a GE Electric Range Oven typically costs $15–$35 DIY, $80–$150 at a third-party shop, or $120–$200 through GE. The repair is rated Easy (3/10) and takes about 20 minutes. At 13% of appliance value, this repair is usually worth doing.
DIY Cost
$15-$35
Time Required
~20 min
Difficulty
Easy (3/10)
Official Warranty
1 year
Cost Comparison
DIY Repair
$15-$35
Parts only — you do the labor
Third-Party Shop
$80-$150
Parts + professional labor
Official Repair
$120-$200
Manufacturer service center
Tools & Parts Needed (DIY)
Always use the correct tools for your specific model. Using wrong-sized screwdrivers can strip screws and cause additional damage.
Step-by-Step DIY Guide
Follow these steps carefully. Take photos at each stage for reference during reassembly.
Unplug the oven
Disconnect your GE Electric Range Oven from power or turn off the breaker.
Locate the temperature sensor
Open the oven door. The sensor is a thin metal probe, typically at the top rear of the oven cavity. It is held by 1–2 screws.
Remove and test
Remove the mounting screws and pull the sensor into the oven. Disconnect the wire connector. Test resistance with a multimeter — at room temperature it should read approximately 1,100 ohms. Replace if significantly different.
Install and test
Connect the new sensor, push it back through the hole, and secure the screws. Power on, set to 350°F, and verify with an oven thermometer that the temperature is accurate within ±15°F.
Is It Worth Repairing?
Your GE Electric Range Oven is currently worth approximately $900. A temperature sensor through a third-party shop costs $80-$150, which is 13% of the device value.
This repair is worth it. The cost is well below 50% of the device value, making repair the financially smart choice.
Frequently Asked Questions
How much does temperature sensor cost for a GE Electric Range Oven?
DIY parts run $15–$35. An independent shop charges $80–$150 including labor. Official GE service costs $120–$200. The DIY route saves the most but you take on the risk of further damage; shops are the middle ground; official is the safest if warranty matters.
How do I test the oven temperature sensor before replacing it?
An oven temperature sensor (typically an RTD — resistance temperature detector) reads 1,080–1,100 ohms at room temperature. Disconnect it from the back of the oven, measure across its two pins with a multimeter, and compare to that range. Way off (open circuit or near-zero) means the sensor failed; in spec means the problem is elsewhere — usually the control board or the wiring between the sensor and the board.
How long does temperature sensor take and how hard is it?
Plan on about 20 minutes for the work itself, rated Easy (3/10). First-time DIY attempts typically take 50–100% longer because of unfamiliar parts and tools. At this difficulty most owners can do it with a basic toolkit and a video guide.
What warranty options come with each repair path?
DIY: no labor warranty — the parts carry their own (usually 30–90 days from the supplier). Independent shops typically offer 90 days on parts and labor. GE official service comes with 1 year. If keeping the manufacturer warranty intact matters to you, the official route is the only one that does that — third-party work generally voids any remaining manufacturer coverage.
Is repairing my GE Electric Range Oven worth it vs replacing it?
Your GE Electric Range Oven is worth roughly $900. A shop temperature sensor costs $80–$150, which is about 13% of device value. At this ratio, repair is the clear winner — you save more than 65% vs replacement.
External Resources
Trusted third-party resources for this repair: